Magnet power supply MercuryiPS
This magnet power supply is accurate, intelligent, upgradable.
- 60A and 120A standard configuration with modular design up to 480 A.
- Output voltage ± 10 V
- Full range of bi-polar output
- Highly accurate to < 3 mA current stability
- Low noise
- iSense intelligent magnet monitoring
- Quench protection
- Temperature and cryogen level monitoring
- Configurable as Master and Slave modules
- Supports vector rotate magnets
- Full range of interface options (Ethernet, USB, RS232)
**SPECIAL OFFER** 
Trade-in an Oxford Instruments magnet power supply and we will offer you
15 % off a new one.
MercuryiPS MPSU Master + 1 x Slave: Parallel Mode. Ramping* 43H magnet
*Target ramp rate is set to 12 A/min. As a demonstration the
positive current ramp is limited by a multi-zone ramp rate limit table.
For the ramp from 0 to 30 A the rate is limited to 11 A/min, then
7 A/min from 30 A to 50 A, then 5 A/min from 50 A to 80 A, then
3 A/min from 80 A to 100 A. The ramp back to 0 mirrors the ramp up.
-
Configurable module specifications
-
Input
-
Interface
-
Pictures
-
| Output current |
±60 A via rear panel busbar per module |
| Output voltage |
± 10 V |
| Output polarity |
Bi-polar |
| Current resolution |
0.15 mA |
| Current stability |
± 2mA or 0.005% per oC |
| Current ripple |
<0.001% |
| Max sweep rate |
300 A/min |
| Resolution |
0.01 A/min |
| Load inductance |
Up to 1000H |
| Switch heater output |
0 to 120 mA into 0 - 100 ohms.
12 V max |
| Max steady state power |
600 W |
| Mains input |
3 pin UL/CSA compliant. Auto range setting |
| Supply voltage |
90 to 264 VAC |
| Frequency |
47 to 63Hz |
| RS232 |
With isobus support. Configured as DCE |
| Ethernet |
10/100 RS422 IEE802.3 |
| USB |
Serial port |
| GPIB |
IEEE-488 (Option) |
| SPI bus |
Control between Master and Slave |